Detect Slave Client Disconnect
Justin Will (4/3/14 9:09PM)
David Adams (4/4/14 2:13PM)
Justin Will (4/3/14 9:09 PM)
I have a slave workstation that occasionally disconnects from 4D.
?When this
happens 4D stays running but it throws an error with a Restart button.
?Does
anyone have a way to detect when this happens and quit out of 4D or
some way
to auto recover from this type of an error?
Thanks
Justin
David Adams (4/4/14 2:13 PM)
<CAPXPcQtN01z9o7jN0tL6Mq0GQH2k0X_GJ6S28Yk-wvKskihVJA@...
One thought:
* REGISTER CLIENT.
* Have a stored procedure scan for the expected client count every
minute/ten minutes/you decide.
* If it hits zero for your task workstation...and thus ends my
thought...not a complete solution, but something to start from.
Reply to this message
Summary created 4/4/14 at 11:08AM by Intellex Corporation
Comments welcome at: feedback@intellexcorp.com